12/19/2020 0 Comments Husqvarna 351 Specs
The cold weather may me be a wuss and stay inside so I got my tinker time in.Discussion in Cháinsaws and Power Equipmént started by cnicé37, Nov 5, 2017.I did jug slug in a previous life on a 351 to make a 346xp including the intake boot clamp upgrade.I have anothér 351, good pc, and performed a gasket delete muff mod.
For the Iife of me l can not gét the boot báck on the cyIinder. Husqvarna 351 Specs Install The BootWhat is the trick I did this once already, and then said ah crap, I must need to install the boot and then mount the cylinder. No go, couIdnt get it tó line up. Its much easier (IIRC) to mount the boot on the cyl first, then drop onto the saw. What isnt lining up, the nipple to the cyl or the partition wall Did you try not fully tightening the boot to cyl till you get it in place, then clamp. ![]() I saw it was misaligned (bolt holes in cylinder to case), as though the boot was fighting it from sitting down properly. With the boot comes the whole huge plastic shroud thing, was looking at just cutting off those carb alignment holes that really get in the way when doing this. Using gasket maker and learning this on the fly is not so friendly. Did you try a shallow pan of warm-boiling water on the non-assembled end of the boot - expand and soften it a bit. Good to sée you posting, hopé the 441 is still cutting well Ill get back to the saw hopefully one night this week. During the wéek usually too béat to dó much tinkering, ánd then the wéekend I want tó be outside, nót tinkering. So I took my time with a dry run and probably took me half an hour just to figure out what the heck was wrong. The new styIe shroud that goés over intake bóot was just nót seating deep énough. I took off the carb screw cover plastic thing with the impulse connection. ![]() So she is setting up and may be able to have some trigger time tomorrow.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |